Furnaces
Furnace repair in Tampa Bay
A furnace that will not light, blows cold air, or smells wrong? Our stocked trucks fix most Tampa Bay furnace problems on the first visit.
The short answer
Furnace repair in Tampa cannot wait when a cold front has your home in the 50s and your heat will not come on. FL HVAC Team sends a licensed technician who diagnoses the real failure, whether it is a dead igniter, a dirty flame sensor, a failed blower motor or a cracked heat exchanger, then shows you a flat-rate price before touching a wrench. Most repairs finish the same day because our vans carry the parts that fail most often when a furnace wakes up after a long idle summer.
A furnace that sits unused most of the Tampa year rarely fails gracefully. Dust bakes onto the flame sensor, the igniter weakens, the blower bearings dry out and rodents sometimes chew wiring near the cabinet. Add a humid garage or attic where many Tampa furnaces live, and corrosion speeds things along. We trace the symptom back to its cause and check the system for safety instead of just swapping the obvious part, so the same fault does not leave you cold again next week.
What we handle
Common furnaces jobs
No ignition or no flame
A dead igniter, a dirty flame sensor or a faulty gas valve stops the burner from lighting. We test, confirm and quote the fix.
Blows cold or short cycles
A tripped limit switch, a clogged filter or a failing blower makes a furnace run then quit. We find the real restriction, not just the symptom.
Cracked heat exchanger and safety faults
On gas furnaces we inspect the heat exchanger and test for carbon monoxide, because a crack is a safety issue, not just a repair.
Electric furnace and element failures
Burned-out heating elements, a bad sequencer or a tripped breaker leave an electric furnace cold. We test each element and correct the cause.
How it works
Our process
Step 01
Call or book
Tell us the symptom and we give you a real arrival window, not a vague all-day wait.
Step 02
Free diagnosis and estimate
The technician inspects the furnace, runs a safety check, shows you the failed part, and gives you a flat-rate repair price at no charge before any work begins.
Step 03
Same-visit fix
You approve the price and we complete most repairs on the spot, then confirm the furnace is heating safely before we leave.
Every visit
What’s included
Clear, upfront work with no surprises. Call (813) 603-6398 and we will get started.
- Full furnace inspection, not just the obvious part
- Heat exchanger and carbon monoxide safety check on gas units
- Flat-rate price approved before work starts
- Common igniter, sensor and control parts stocked on every truck
- Ignition, burner and blower testing
- A heat check and cleanup before we go, with workmanship backed by our guarantee
Upfront about pricing
What affects the cost
Every job is quoted flat-rate before work starts. Here is what moves the number.
The failed component
An igniter or flame sensor is a quick, low-cost fix. A blower motor, control board or heat exchanger is a larger repair, and we tell you honestly which you are facing.
Gas or electric
Gas furnace repairs can involve the burner, valve or heat exchanger, while electric repairs center on elements and sequencers. The system type shifts the cost.
Furnace age
On an older furnace we show you repair-versus-replace numbers, especially if the heat exchanger is cracked, so you do not pour money into a unit near the end of its life.
Rated 5.0 from 145 reviews
Tampa Bay homeowners trust us for punctual, flat-rate service. Read what your neighbors say, or add your own.
Read our Google reviewsGood questions
Before you book
How much does a furnace repair cost in Tampa?
We provide a free diagnostic and estimate, then a flat-rate repair price you approve before any work begins. No hourly meter and no surprise add-ons.
Why will my furnace not ignite?
The usual causes are a worn igniter, a dirty flame sensor, a tripped safety switch or a gas supply issue. After a long Tampa summer idle, the igniter and sensor are the most common culprits, and we test to confirm which one it is.
My furnace blows cold air. What is wrong?
It could be a thermostat setting, a clogged filter tripping the limit switch, a flame sensor fault or, on a heat pump, a system in defrost. We diagnose the real cause rather than guessing.
Is it safe to keep running a furnace that smells like burning?
A faint dust smell on the first startup of the season is normal and clears fast. A smell that lingers, smells electrical, or smells like gas means you should shut it off and call us to inspect it safely.
Should I repair or replace my furnace?
If the furnace is sound and the repair is minor, repair wins. If it is old or the heat exchanger is cracked, we show you repair-versus-replace numbers so you decide with no pressure.
Do you check for carbon monoxide?
Yes. On every gas furnace repair we inspect the heat exchanger and test for carbon monoxide, because a crack can leak CO into your home. If we find one, we will not leave it running unsafely.
Do you repair furnaces on weekends and at night?
Yes. We run 24/7, including weekends and holidays, because Tampa cold snaps do not keep business hours. A real dispatcher answers, not a call center.
Is my furnace repair under warranty?
Many parts carry a manufacturer warranty, and our workmanship is guaranteed. Share the model details and we will check your coverage before quoting.
Why FL HVAC Team
Neighbors who show up
Safety on every visit
We check the heat exchanger and test for carbon monoxide on gas furnaces, so a repair never leaves a hidden hazard behind.
Flat-rate, no meter
You approve one price up front. No hourly clock, no surprise add-ons at the end.
Honest diagnosis
We show you the failed part and repair what is broken. No scare tactics, no upsell on a furnace you barely run.
Let's get you comfortable
Call the county line closest to you and we will get a technician headed your way. Office hours: 24/7.